Stock on Hand: Category Group in SNP Planning Area

[Former Member]

Experts,

I am exploring a basic SNP solution based on standard SNP planning book

Why do Stock on Hand key fig with tech name STOCKD. ATD issue key fig with tech name 9AATDAB and Stock on hand projected key fig with tech name STOCK. all refer to the same BI field name /BI0/9AATDAB ?

What does it mean?

Isnt Stock on Hand and Stock on Hand projected both calculated using Macros? in standard SNP planning area are these Auxiliary Key Figures? If they are Aux, whey then do they 'refer' to the BI field /BI0/9AATDAB ?

[rupesh_brahmankar · Accepted solution]

Hello,

You have asked so many queries in a discussion.

Macro function INITIAL_STOCK will show the aggregated stock value INITIAL_STOCK macro function reads data from stock category group If you did not define anything there by default it reads CC category.

In SNP interactive planning, reading data for keyfigures for 'ATD Receipts' and 'ATD Issues' is considered the category group which is defined in the master data SNP tab, if not then category group defined in the keyfigure.

You can CIF the stock from R/3 to APO . Once the stock is in APO, you can use Physical_stock( ) function to pull the stock to SNP planning book.

Check macro name is "Stock Balance" and "Stock on Hand"

macro Physical_Stock, you can use in way to exclude the block stock etc.

9ASTOCK key figure capacity consumption of the storage resources and the relevant order quantities In SNP capacity view, you are loading the data for a storage resource and the Quantity Stored keyfigure are used The calculations for this Key Figure are determined by the Key Figure Function assigned in the Planning Area.

Please refer this discussion which is for same topic.

capacity in in SNP capacity view

Planning-book-key-figure-and-macro

Best Regards,

R.Brahmankar