SNP Planning Area - Error when Checking or Saving

[Former Member]

Hello Friends,

Looking for help identifying the cause of the following error message we receive when trying to Check or Save an SNP Planning Area.

We recently added Key Figure 9ASVTTY so we could maintain utilize the MZ (Time Phased) Safety functionality. This is working as desired.However, if we now go into our planning area admin. /SAPAPO/MSDP_ADMIN open up our planning area and click the Check Planning Ares icon, we receive the following error message. Search of the forums, SAP support etc yields nothing relevant for our current SCM version 713 EP11.I have also ran all of the consistency checks I am aware of.

Note: We also get the message if we try to save a change of the Planning Areas, both when active and deactivated.

ANy hints or recommended things to try would be appreciated

Key Fig. 9ASVTTY: Inconsistency btwn master plan.obj.struct.and agg.

Message No. /SAPAPO/TSM394

[rupesh_brahmankar · Accepted solution]

Hello,

I am not sure if you have executed following reports.

Run transaction /SAPAPO/OM17 to ensure DP time series are consistent in all planning versions. Run transaction /SAPAPO/TSCONS to find and correct inconsistencies in the planning areas.

Also execute report /SAPAPO/TS_LCM_CONS_CHECK and /SAPAPO/TS_LCM_PAREA_CHANGE2

Could you please try it once?

Work around would be to do the de-initialization and re-initialization of the Planning Area.

You can check the steps in the following Wiki page:

Deinitializing and reinitializing a Planning Area on SCM-APO system

Please test this carefully in quality system.

Please share the screen shot of table /SAPAPO/TSPAPLOB key figure 9ASVTTY

Best Regards,

R.Brahmankar

[Former Member]

Thanks R Brahmankar.

None of the consistency checks solved the issue, but your suggestion to review contents of table /SAPAPO/TSPAPLOB pointed me in the right directions. Looks like when adding the Key Figure to our planning area we assigned accuracy to 3 DP. This should be 0 DP sas defined in the sample planning area 9ASNP05. I was able to change this setting without deinitializing planning area and now error is gone.

Thanks again for the quick response.