SNP Keyfigure needs to be changed to editable.

[former_member620505]

We have created Z key figure which is used in SNP with category group "ZF" and key figure function as blank.currently its in output mode only which is not allowing us to change it to input/output.

while trying to change we are getting error message "

Key figure <**********> must not be set to ready for input

Message No. /SAPAPO/MSDP_PB055 3

"

How Can we do this change and without activating the planning area?

Also explain what changes needs to be done?

If we activate the SNP planning area, after KF modifications will there be data loss?

...

[rupesh_brahmankar]

Hello,

In SNP it is not possible to have edit functaion for all keyfigures.

To make a keyfigure as input it is necessary to take a keyfigure function which allows input.

Please refer this old discussion on same topic.

How to make SNP order based KF editable

Best Regards,

R.Brahmankar