SAP IBP Time Series | Mode of Transport Configuration Errors

[former_member806699]

Hello Experts

To configuring the Mode of Transport for Time-Series Planning, followed the steps by SAP as per the below link -

https://help.sap.com/viewer/feae3cea3cc549aaa9d9de7d363a83e6/2202/en-US/6896c69dfef04b4f9d322f99dc76...

- Created Simple MD MODEOFTRANSPORT with MOTID & MOTDESC.
- Added MD MODEOFTRANSPORT in Location Source which made MOTID as Key & Required.
- added MOTID as root in PERPRODLOCCUST, PERPRODLOCLOCFR, PERPRODLOCTOLOC, PERPRODLOCCUSTAGG, PERPRODLOCLOCFRAGG, and PERPRODLOCTOLOCAGG base planning levels and did add the same in all the other related planning levels.
- Now when I try to activate the Planning Area, it gives below 4 errors (Also attached)

locationsource-mdt.png

[manikandan_shanmugam3]

Try this once. revert planning area changes, Purge key figure data, delete master data and also run purge non confirming data job before configuration.

Regards,

Manikandan

[manikandan_shanmugam3]

Did you purge location source master data and key figure data for those planning level that MOT ID will be added as root attribute before configuration?

Regards,

Manikandan

[former_member806699]

Hi Manikandan,
Yes - As the Steps prescribed by SAP, I did purge the Master data and the KF data purge was the step after doing the PL changes. hence did not run the purge before the Config.

Thanks.