Missing FIN_DIS2 Function Profile In FSCM

[Former Member]

Hello,

I am not able to see the Buttons inside the Dispute Management Screen.

I think the problem is...that I don't have this FIN_DIS2.

Is it possible to create this profile(FIN_DIS2)?...or I need to activate it somewhere?

Please help me with this.

Thanks in Advance

Ashish

[Former Member · Accepted solution]

check you have activated all of the required business function sets and specific BC sets.

Assume you are beyond Enh Pack 2

You might also need to adjust from client 000 the standard config values

[Former Member · Accepted solution]

This message was moderated.

[Former Member · Accepted solution]

Hi Mark

Thank you so much.

(1) I have checked the Business Function and they are active.

(2) If I am on EHP7...I have the functionality of EHP2..right..?

Or...I have to activate it somewhere..?

(3) Can you please tell me...what standard config. I have to perform.

Thank You

Ashish

[Former Member · Accepted solution]

In the create profile config screen - use the adjustment function to copy the values from client 000

In order for you to see the customer disputed objects - the dispute case type needs to have the correct profile

[Former Member · Accepted solution]

So...this is not a problem related to EHP upgrade...?

[Former Member · Accepted solution]

I don't know - you said you have the business functions active

Does that mean - you have FIN_FSCM_CCD and FIN_FSCM_INTEGRATION activated?

SFW5 is the place to check

I would activated ALL of the FIN_FSCM business function sets if you are on Enhancement Pack 7

[Former Member · Accepted solution]

Yes.....I have checked the Business Functions in SFW5.

FIN_FSCM_CCD

.................._CCD2

.............................

FIN_FSCM_INTEGRATION

.................._INTEGRATION2

............................................

All are active.

[Former Member · Accepted solution]

OK- so if you cant see the profile in the create profile screen - you need to copy the standard config from client 000 - via adjustment as mentioned

[Former Member · Accepted solution]

You mean in SPRO...?

[Former Member · Accepted solution]

Yes

[Former Member · Accepted solution]

Can you please Guide me for this process..?

[Former Member · Accepted solution]

Environment >> Adjustment

you will need an RFC connection to client 000 built - get BASIS to do that

[Former Member · Accepted solution]

Ok...Mark

I have now RFC connection between the two client.

And I am Inside the Adjustment Screen

But I am not able to see the FIN_DIS2...inside this screen.

Thank You

[Former Member · Accepted solution]

So from your dev system - you have gone into config - and click the adjustment button - selected client 000?

The value should be there in client 000 - you then need to copy that back into your dev system - by selecting the tick boxes

[Former Member · Accepted solution]

As I am on Sandbox....I can't see it on Sandbox 000 client.

can I pull it from DEV 000 client.?

[Former Member · Accepted solution]

Hi Mark,

In SCPR20 transaction...when I am trying to activate the "UDM_CUST_CCM" BC Set.

It comes with so many error.

[Former Member · Accepted solution]

can you work with your BASIS consultant please?

in SFW5 - the BFS - should be seen as active.

You should need to activate the lower nodes - it should all be done at the higher level.

[Former Member · Accepted solution]

Thanks Mark