Interoperation time not taken into account while scheduling

[ninad_narad]

Hi,

I have entered standard queue time in the work centre. This time is getting replicated in the PDS in the form of average interoperation time which is correct.

Whenever I am running MRP with MD01n( infinite planning) this interoperation time is not getting used while scheduling. My 1st operation is ending at 21:00:00 and second operation is starting immediately. Ideally it should have started with a 20 mins delay(time maintained in the work centre)

Can you please suggest.

Regards,

Ninad

[Sasi2005]

Hi,

As replied by Rupesh, if you are running MD01n you need to use option 2 (lead time scheduling and capacity planning ) for considering the timings. Also make sure that the production version is maintained for the material. Please refer to OSS note 2461479 - No Lead Time Scheduling in t-code MD01N for Planned Orders

Hope this helps.

Regards

Sasi

[former_member609212]

Same issue. PPDS just consider the interoperation time when planned orders are created. When you try to schedule/plan them, this time is not considered.

[ninad_narad]

Hi Alex,

It is working fine for us now. Check note 2906502 as well if you have an issue with fixed duration and min send ahead quantity.

[ninad_narad]

Hi,

We are using embedded ppds so we are planning the material in ppds. I am running basic data(infinite scheduling).

I had referred this note but this note only gives information on where I will see this data in PDS.

My issue is that even though these values are in PDS but the planning is not respecting these values.

Regards,

Ninad Narad

[rupesh_brahmankar]

Hello,

Are you planing the material in ECC or in SCM?

Are you running MRP with lead time scheduling?

Check whether a minimum wait time has been entered in the operation

Please refer SAP knowledge base article 2696048 - Usage of interoperation times within Product Data Structure (PDS)

Best Rrgards,

R.Brahmankar