EWM - entitled to dispose not allowed in tcode /scwm/psastage

[pedern]

Hello,

I'm setting up a new WH on embedded 2020 and are having some struggles with the /scwm/psastage transaction.
When Entering the entitled to dispose I get an error message that it's not allowed in the WH.

I have maintained the plant in stock transfer order, maintained BP with customer and vendor. Assigned entitled to dispose to supply chain unit etc

I'm allowed to extend a material in /scwm/mat1 with said entitled to dispose but not in /scwm/psastage.
Any suggestions here on why /scwm/psastage is beeing difficult?

Best Regards

Peder

[former_member788724 · Accepted solution]

Hello,

Please check below points

1- A unique BP should be assigned to your plant. you can check that by assigning plant to any other BP in BP transaction. S4 HANA 2020s check the duplicate assignment by looking into the table T001W once you try to assign plant to a BP .

2- What F4 options you see for the party entitled to dispose field?

You may have BP assigned as vendor and customer to plant , but party entitled to dispose definition may not be complete even after this assignment is updated in T001W.

3- Please must check the mapping table /SCWM/TMAPSTLOC. if this table is done then you can see entitled to dispose list in F4 .

Regards- ASLAM

[pedern · Accepted solution]

I will mark this as the anwer since it Aslam mentioned the tcode /SCWM/TMAPSTLOC here. The issue was that the tcode is setup as a transportable configuration step, but the logical system does not change in each client. In reality you would either have to enter in all the client combinations in the tcode or open up the tcode for editing in each of the clients and add the values with correct logical system there.

Br Peder