Error received during RF Picking confirmation: /SCWM/L3046

[sushanta_dash]

Dear Community members,

I am getting the below error during confirmation of Pick HU WO.

Whse process control must not be deactivated acc. to whse proc. cat XXXX /SCWM/L3046

While I can confirm the same WO without any issue through /scwm/mon. (warehouse monitor)

I tried to look for the reason of this error message and it's as below.

The warehouse process type does not allow WT creation or repacking for HUs with warehouse process control.

This WO for POSC is not doing any repacking, it's just trying to take the product with pick HU.

Moreover why the same WO is getting confirmed normally without any issue.

rf-picking-error.png

Regards,

Sushanta

[Private_Member_324719 · Accepted solution]

Hi,

Which WPT do you use for creating the inital WT of the Pick-HU?

Here:

Try setting the '3' on this WPT, not on the stock removal WPT.

João

[sushanta_dash]

Hi Joao,

Thanks. Yes, I had the incorrect assignment of WPT PIK1 here. Now after assigning the correct WPT it's working good.

Many thanks for your help.

Regards,

sushanta

[sushanta_dash]

Hi Joao,

Thanks. Yes, I had the incorrect assignment of WPT PIK1 here. Now after assigning the correct WPT it's working good.

Many thanks for your help.

Regards,

sushanta

[Private_Member_324719]

Hi Sushanta,

Try choosing the option 3 (Storage Control is not Relevant) for the settings 'Storage Control Relevance' in the WPT.

João

[sushanta_dash]

Hello Joao,

Thanks for your reply. Yes, I can do that. but if I do that change suggested by you I am getting the same error during WT creation from ODO as shown in the attached document.

attachment.png

Regards,

Sushanta