Cannot find inspection object type 3 in EWM on S/4Hana 1709

[former_member573898]

Hi EWM experts,

We just got the S/4HANA 1709 installed, FPS2. I checked the quality management in EWM and couldn't find the IoT 3.

According to SAP note 2494704, IoT 3 is supported in 1709 already.

So, is there any other SAP note we need to implement?

[former_member598149]

Hello lebaotri ,

Sorry for late reply as i was on vacation

yes for us also it is coming in Warehouse-Dependent Activation of Inspection Object Type but one short question were you able to run the scenario or you also get stuck ? because we it to further setup the scenario

Thanks

[former_member573898]

Hi Andy,

I've been busy with other matters so I haven't tested yet...

[former_member598149]

Hello lebaotri

thank you for the response

we have tried to activate the same BC set but it ended up with warning (please see the attachment) , but still we dont have IOT3 showing SPRO

any hint would be highly appreciated

[former_member573898]

Hi Andy,

I ran into the same problem. I think the answer doesn't lie in the BC set because it only generate delivery related settings.

After activation, I went to the see if IOT 3 was there, at 'Generate Inspection Object Types Version' but I found none.

However, when you go to the node 'Warehouse-Dependent Activation of Inspection Object Type', and press F4 on the IoT, you can see the IoT 3 is there

I haven't checked the full customization because of current workload...

Maybe you could help to check further...

[former_member573898]

Hi Andy,

The BC Set is /SCWM/DLV_ADVANCED_RETURNS.

[former_member573898]

It's OK, I need to activate the BC Set.

[former_member598149]

Hello lebaotri

we are facing the same issue could you please let us know which BC sets we need to activate.

Thank you in advance