Automatic Warehouse Task after MIGO movement type 311

[LuizHuelsmann]

Hi all

I have a scenario for automatic creation of warehouse task after movement type 311 from a MM plant to a EWM plant.

SAP create a inbound delivery, after creation of document we need the automation of warehouse task (/SCWM/PRDI).

prdi.png

I allready check some posts about this scenario and create the following configuration.

SPPFCADM:

prdi-1.png
prdi-2.png

Maintain Determination Procedure:

determination-procedure.png

Define Conditions:

define-conditions.png

Even with this configuration WT was not automatic created.

Best Regards
Luiz Huelsmann

[MarekKaminski · Accepted solution]

Hi,

Please look at this link (page 23):

How to use PPF in EWM

Best regards,

Marek

[LuizHuelsmann · Accepted solution]

Hi, I will check and return.

Best regards
Luiz Huelsmann

[LuizHuelsmann · Accepted solution]

Hi Marek

I tried your suggestion as You can see below.
But still not working.
I will continue searching in PPF Document.

Best regards
Luiz Huelsmann

[former_member375562]

also check if you have maintained the entry in "assign determination procedure" under "configure action scheduling" node

[LuizHuelsmann]

Hi Sai Anwesh Domakonda.

Where can I check your information?

Best Regards
Luiz Huelsmann

[schulte-bahrenberg]

Hi Luiz,

have you tried to set the 'Change Mode' field in the condition record to 'I'?

If it is still not working I would suggest putting a breakpoint in the scheduling Badi after the filter value has been evaluated (see screenshots below). This way you should be able to narrow down which customizing is missing or which condition record might be needed:

ppf.png

ppf-2.png

[LuizHuelsmann]

Hi Hendrik

Can You please in wich transaction can I find:

set the 'Change Mode' field in the condition record to 'I'.

Best Regards
Luiz Huelsmann

[LuizHuelsmann]

Hi Hendrik, I found the field.
Now we will chek the breakpoint.

[LuizHuelsmann]

Hi Marek

I created the conditions following instructions in SAP Document.

The maintenance group DLVP is used for print.

I select the configurations as the document explain.

The Condition Type 0DWTP is not possible, only 0DDN and 0DFL.

So, I created the configuration for maintenance group DLVW as below.

I will continue the research and testing based on the PPF document.

Best Regards
Luiz Huelsmann