After freight unit split the newly created outbound delivery order ODO can not be loaded via RF

[reinerinkrob]

Hi Experts,

When we split a freight unit in ASR (either through RF or through deleten of the handling unit in the freight order) a new freight unit is created. Simultaneously, a new outbound delivery order is created (as off S4H 2021 FPS1).

We then continue with creating a new freight order for the new freight unit. When we then want to load this new ODO with RF we get the error message 'E: Loading cannot begin until freight order is assigned. (/SCWM/SHP_RCV679)'. Even though a freight order is created for this ODO and freight unit. Below an example of the newly created ODO's (starting with 9*) and their assigned FO's.

We also receive this error in the 'load/unload of freight order' app. It seems some references to predecessor documents are not filled in table /scmtms/d_torrot for the newly created freight unit.

Have seen many notes, but have not found the solution.

[reinerinkrob · Accepted solution]

After a lot of notes, hours and coffee we found note https://launchpad.support.sap.com/#/notes/3212739 which helped us.

[reinerinkrob]

Hi Carlos,

Is it possible to split the FU when performing loading through RF? There you can set the loading to completed as well, which causes the FU-split to occur.

Secondly, is there a loading point determined in your EWM ODO? I think a loading point is necessary to split the FU when doing it through loading. I am not certain if you need when trying to split it with 'Load/unload freight orders', but you definitely need it when splitting it with RF. I think you can determine it through /scwm/door_scu this, but am not sure if this is the only thing you have to set.

[carlosgarridolopez]

Hi Rob,

Is it possible to split a FU using the ASR tool?

We are using the 'Load or Unload Freight Orders' application and what we do is:

1. Set one of the 2 packages of the FO in finished cargo

2. Set 'Stop on finished loading'

Result: does not divide the FU.

Do you have any thoughts?

[carlosgarridolopez]

Hi Rob,

Is it possible to split a FU using the ASR tool?

We are using the 'Load or Unload Freight Orders' application and what we do is:

1. Set one of the 2 packages of the FO in finished cargo

2. Set 'Stop on finished loading'

Result: does not divide the FU.

Do you have any thoughts?

[carlosgarridolopez]

Hi Rob,

Is it possible to split a FU using the ASR tool?

We are using the 'Load or Unload Freight Orders' application and what we do is:

1. Set one of the 2 packages of the FO in finished cargo

2. Set 'Stop on finished loading'

Result: does not divide the FU.

Do you have any thoughts?