Quantity decimals 0.XXX does not match unit of measure EA customizing

[Former Member]

Hello Experts,

We are upgrading from SRM 4.0 to SRM 7.0. We have classic scenario with ECC as a backend system.

We have created SC with certain quantities to be ordered and UOM as 'EA'. PR and PO is created in ECC.

When we try to post confirmation with quantity: 0.03 EA, system gives error: 'Quantity Decimals 0.030 does not match unit of measure EA customizizng.

I checked the CUNI settings, they are as below:

Decimal Places 0

float point exp 0

Decimal Places rounding 0

Earlier in SRM 4.0, we also had similar CUNI settings, but we never received error message if quantity was entered in decimals for 'EA'.

I am not sure if this error message was suppessed in SRM 4.0. Is there any way to find it out?

Further, while SC creation, if I enter Quantity as 2.3 EA,

1. SRM 4.0 system consider it as '2.3' EA

2. While SRM 7.0 rounds it to '3' EA

Is there anything changed in SRM 7.0?  Are there any further settings apart from CUNI to be checked?

Can anyone pls advise what standard behavior would be?

Thanks,

Dhananjay

[oliver_wurm]

Hi Dhananjay,

the strict check against table T006 was introduced with OSS Note 1874190 so it came quite late into the SRM Solution. And OSS Note 2011639 does not Change anything for Extended Classic Scenario - it is limited to a One Client implementation.

So in every Release of SRM 7xx with OSS Note 1874190 implemented which is not a one Client implementation the strict check against table T006 is Standard.

Regards

Oliver