Quantity decimals 0.XXX does not match unit of measure EA customizing

[Former Member]

Hello Experts,

We are upgrading from SRM 4.0 to SRM 7.0. We have classic scenario with ECC as a backend system.

We have created SC with certain quantities to be ordered and UOM as 'EA'. PR and PO is created in ECC.

When we try to post confirmation with quantity: 0.03 EA, system gives error: 'Quantity Decimals 0.030 does not match unit of measure EA customizizng.

I checked the CUNI settings, they are as below:

Decimal Places 0

float point exp 0

Decimal Places rounding 0

Earlier in SRM 4.0, we also had similar CUNI settings, but we never received error message if quantity was entered in decimals for 'EA'.

I am not sure if this error message was suppessed in SRM 4.0. Is there any way to find it out?

Further, while SC creation, if I enter Quantity as 2.3 EA,

1. SRM 4.0 system consider it as '2.3' EA

2. While SRM 7.0 rounds it to '3' EA

Is there anything changed in SRM 7.0?  Are there any further settings apart from CUNI to be checked?

Can anyone pls advise what standard behavior would be?

Thanks,

Dhananjay

[Former Member]

Hello Dhananjay,

Did you find an answer for your question? We are upgrading from SRM4 to SRM7 and we have the same issue.

Thanks in advance.

Regards,

Muzamil

[ricardo_cavedini]

Hello,

Read the explanation provided in note 2138347.
It explains why this error i raised.

Regards,
Ricardo