Plan Driven Procurement - PR not getting transferred

[Former Member]

Hi Experts,

<< Moderator message - Everyone's problem is important. Please do not ask for help quickly. >>

We are on SRM 5.0 , ECC 6.0 ,Extended Classic Scenario.

I am trying to setup PDP in SRM.

RFC connections have been setup.

The required entries in the tables V_160PR and V_160EX have been maintained and mapped for the required Logical sys and Material grp.

I created a Local Company code and inside it i have created Local P.Org and P.grp and assigned the RFC user.

The required attributes have been setup as per the config guide.

I have 2 issues here.

I have 2 PR's which were generated from MRP .

Issue 1:

For one PR , when i run BBP_EXTREQ_TRANSFER , i can see the PR gets transferred indicated as '1' but in SMQ1 (outbound Queue of ECC ) , i see the Queue stuck up with the status "ANORETRY".

I checked the SLG1 log in SRM and i have 2 errors

1. User not Responsible for Purchasing Group of given Material

2.Transaction type for local system missing.

I created a Local Company code and flagged it as Company because i was getting an error"No address found for partner function type Ship-To Address" initially . I went through forums and per the suggestions i could resolve this error by creating the Local Company code but now i get the error "User not Responsible for Purchasing Group of given Material" in place of that.

I have initially tried with ECDP and later with ECPO but no use.

In BBP_PD, i see no Shopping carts that got created.

Issue 2:

Except the above PR, if i run the BBP_EXTREQ_TRANSFER report for any PR that i created later, the PR doen't even gets transferred . We are not maintaining EPRTRANS table so i dont see any entries there.

For this issue, i see nothing in SMQ1,SLG1.

What could be the probable reasons as why it is not getting transferred. And why is it that the BBP_EXTREQ_TRANSFER report is working for only the 1st PR and not anything else.

Any Ideas, clues...pls ...

Thanks,

Addy

Edited by: Rob Burbank on Dec 6, 2010 4:08 PM

[Former Member]

Issue Resolved.

Thanks,

Addy