Error in IDOC load for BBP_PCSTAT Partner Profiles

[Former Member]

HI,

We use BBP_PCSTAT to load p-card transactions in to SRM on an inbound IDOC. This has worked fine for two years & now suddenly we are getting problems!!

the first record in the interface file loads fine - the idoc succeeds with a status of 53. Each subsequent idoc fails with status of 51 and the following error:

No partner profile (outbound parameter) could be found using the following key:

/0000000000/LS//////

This refers to the key fields in table EDP13:

RCVPRN Partner number

RCVPRT Partner type

RCVPFC Partner function

MESTYP Logical message

MESTYP Message code

MESCOD Message function

TEST Test indicator

Procedure

Please check the EDI partner profiles.

Has anyone seen this before?? we are a bit stuck now!!!!

Many Thanks

[Former Member]

bump! any assistance greatly appreciated - we are in serious trouble with this now!!

[Former Member]

Are the prtner profiles in WE20 still OK?

I assume that you are using an upload program to read the statement in to then populate the idocs too.

[Former Member]

Hi yes, as far as i can see our SRP and ERP systems are in existance in WE20 under logical systems.

We are using a bespoke program to load these through, as part of the parameter process we have a variant the defines the sender and receiver systems. This variant has not changed & nor has the We20 entries as far as we can see..

We ran the process one month ago and everythign was fine.

I dont suppose you are the same Keith Wood worked on the project here at the isle of wight are you?!