2014 Nov 17 12:13 PM
Hello Experts,
I have a requirement to save new entries in "Define Doc. Type Cat. for Consump. Billing and Final Billing" config. I have saved 5 entries which are available in Standard system and apart i want to save two additional entries which i am unable to save, please assist me in saving this requirement.
What i mean to ask in above SPRO level is i will explain below,
I have saved in my present system
DCat Text Doc. Type
01 Consumption Billing CB
02 Final Billing FB
04 Simulation SI
05 Manual Billing MB
These are available in Standard Document Type Category, but i am also trying to save below entries which i am unable to save.
06 Manual Billing (Backbilling) MN
07 Manual final Billing MS
where as i have seen in few projects same above two entries have been saved, which i am sharing in below attachment for your reference.
Please assist me in saving 06 and 07 entries and help me in saving the same.
2014 Nov 17 12:39 PM
Hi Kushal,
Are you getting any error while saving the last two entries for documen type categories 06 & 07.
As per the standard SAP recommendation, you should only allcoate a different document type to each document type category.
Thanks,
Amlan
2014 Nov 17 1:19 PM
Hi Kushal,
What error are you getting?
Please try maintaining it by going to SM30 > TE667.
Regards,
Devashish
2014 Nov 18 4:49 AM
Hi Amlan Jee,
But as my previous project, they were able to save those extra entries as shown in attachment.
2014 Nov 18 4:51 AM
Hi Devashish,
I tried and unable to save through SM30. I am getting Enter a Valid Value error in my system.
Thanks
Kushal
2014 Nov 17 1:23 PM
If your system has only has 01-05 values for domain blartyp, then you cannot enter more values in the table, and the programs shall not be able to use other values. since the programs cannot use the values, then config entries will not be of value.
2014 Nov 18 4:53 AM
Hi Will,
Yes even i accept, but as shown in my attachament of previous project, they were able to save data.
Thanks
Kushal
2014 Nov 18 11:35 AM
Hi Kushal,
I think what has been done in your previous project is you have enetered the document category values at the domain level.
Go to table DD07L and give the domain as BLARTYP and in there you can mainatin the document type categories.
Once you have maintained the above, you can see them in the SPRO configuration.
Hope it helps..
Thanks,
Amlan
2014 Dec 13 10:38 AM
hello,
I saw there are a list of billing type , so anybody can advise me how to execute Manually Billing in FICA? thanks
Regard
Mary