No number range found for object ADRPSTCODE

[Former Member]

I used SR10 to create a new city St. johns.  I entered region NL(this region was just added to the config.).  Next I click Postal codes to create a new postal code.  I entered the postal cod(A1A 5G9) and clicked the create postal code but got the error message: "No number range found for object ADRPSTCODE".

The new region NL was just added to the config. by spro-> 'insert region'.   What else I need to config. to combine the new region, country and postal code?

[william_eastman · Accepted solution]

Use transaction SNRO for object ADRPSTCODE to see what number ranges are defined for the object.  You might then need to create a new one.  If you are giving the ID for the code the same as the actual value, then you need an external number range which can have values A to ZZZZZZZ. 

[Former Member]

01 0000000001         9999999999    0

02 AAAAAAAAAA     ZZZZZZZZZZ  0

[william_eastman]

try changing your 02 range to start with a single A

[Former Member]

Just tried it.  It works.  Thank you so much for your help.

[Astrid_Gambill]

Sounds like you need to check the SNUM transaction for that object, and define a number range.

[Former Member]

But if postal code can be created previously then it should
be OK.

[Former Member]

Hi,

If ur requirement is to maintaine the Regional Postal St. then u can enter the Postal Code  in the CITY , maintain via T-code SR30.

Regards,

AnUrAg