SAP for Utilities Discussions
Connect with fellow SAP users to share best practices, troubleshoot challenges, and collaborate on building a sustainable energy future. Join the discussion.
cancel
Showing results for 
Search instead for 
Did you mean: 

No Grid Level Types found for the selection criteria entered , Message no. E9104

Former Member
0 Kudos
314

I'm trying to add new Grid for my new GAS division, I used transaction ID " EEDMIDE_GRID01"; I field up all the required filed but I could save it and I was getting  the following message " No Grid Level Types found for the selection criteria entered " Message no. E9104. 

I 'm including a screen shot of my screen

Any assistance will be greatly appreciated

6 REPLIES 6

ivor_martin
Active Contributor
0 Kudos
271

Hi,

I have a screenshot of the config path and some brief documentation on what a Grid Level Type is.

You have to configure them if the field is mandatory.

An example for an Electrical grid would be "Voltage Type" where the grid would be broken dowwn based on the Voltage level of the transmission.

I hope this helps.

Regards,

Ivor

0 Kudos
271

Hello

Thank you Ivor for your reply, however I think you forgot to include the snap shot or and the brief documentation for the configuration path.

please reply with the documentation and the screen shot

Thank you and best regards

0 Kudos
271

Hello Ivor

My apologies, I just noticed that you included the documents.

Thank you  very much

0 Kudos
271

Hello Ivor,e

Your guidance was very helpful, however am still encountering another issue ; message" Chose the Key from the allowed name space, I tried to use "0002" for gas   because we already used "0001" for electricity; I'm including  a screen shot for your reference.

Thank you and best regards

0 Kudos
271

Hi,

The allowed namespace messages normally means that you have to use a naming convention starting with "Z" , in this case for the Grid Level Type that you re creating.

You can still proceed, because the message is a warning, and not a hard error. Simply hit enter, and SAP will still accept the entry.

Regards,

Ivor

0 Kudos
271

Thank you , it worked; I still need only one more thing regarding the distributor that I need to allocate to the grid, there is no distributor configured in my system yet.

Thank you again for all your assistance