How to Set disconnection document status

[Former Member]

Hello

In ECC6 , following disconnection statuses are available

23 : Device Removal Started

24 : Device Removal Executed

25 : Device Installation started

26 : Device Installation carried out

27 : All Devices removed and Disconnected

How to set status as 23 : Device Removal Started and 25 : Device installation started..?

[former_member421468]

Hi,

The status is automatically updated by the system.

regards,

Harshal

[Former Member]

Following status are set automatically

01 : Document created

20 : Disocnnection started

21 : Disconnection Entered

22 : Reconnection started

27 : All Devices Removed and Disconnected

30 : Reconnection complete

99 : Complete document

But status 23, 24, 25 and 26 are not set automatically.

Is there any specific work flow / BAPI to set these status..?

[Former Member]

hi Abhijit,

If the device is removed during the disconnection process we get the status as mentioned above(23 and 24), also when device is reinstalled during re connection(25 and 26).

you can check this by executing the transactions manually during disconnection process.

Hope this helps.

Regards,

Rakesh...

[ivor_martin · Accepted solution]

Hi,

There is a user exit that allows you to perform follow-on actions after the entry of meter reading results. Perhaps you could try using this user exit (EXIT_SAPLEL01_005).

I hope this helps you out.

Regards,

Ivor M.