How to create a Meter Reading Order automatically

[Former Member]

Hi,

Could any one please guide me how can we create a meter reading order which is when created automatically pick up the meter reading results from previous plausible meter reading order created.

Suppose if we create a mro through EL01 then the mro automatically picks up the meter reading from previous mro (plausible) and status of it becomes 01-billable.

Please also tell me how MRO is different from Billing Order except the fact that when billing is done the billing order gets deleted.

Please guide.Its very urgent.

Thanks and Regards

Edited by: MPVash Vash on Nov 20, 2008 12:24 PM

Edited by: MPVash Vash on Nov 21, 2008 7:35 AM

[Former Member]

For creating Meter Orders we can use this FM : ISU_S_METERREAD_CREATE

Regards,

Siva

[Former Member]

Hi,

Thanks for your reply.

But i wanted to ask ,how can we rectify a case in which meter readings are automatically estimated when a meter reading order is created through el01.This is happening for only some cases. So i don't think that there can be any issue from IMG activity.So i request you to please guide me to rectify these cases.

Whenever we create a Meter Reading Order through EL01, the meter reading results from previously created MRO comes in the new MRO automatically, the MRO moves automatically in the EL29(Plausible Meter Reading).

Please guide me to rectify these cases.

Thanks and Regards

[Former Member]

Hi Vash,

Check in Spro: device management -> meter reading -> meter reading order -> order creation -> define aut' interpolation.

If the two order readings are in the same entry interval (which is defined in MRU), the system does interpolation of the 'less important reading' according to your settings.

ben

[Former Member]

Hi,

Please guide me if this is happening then should have affected all the the installations in that MRU.

But we are facing this problem only in one installation.

Please guide me how can we resolve this problem.

Thanks and Regards

Edited by: MPVash Vash on Nov 29, 2008 7:46 AM

[Former Member · Accepted solution]

Dear Vash,

Chek out the meter reading category for that particular MRU whether it has been given as automatic estimation (code 03).

Maybe while creating meter reading orders using el01, the tick mark for "use MRC from scheduling" would have been removed and that is for for some orders it would have not been automatically estimated and for the rest where the the tick mark for "use MRC from scheduling" is flagged on, it automatically estimates based on the minimum portion you have given in the corresponding rate.

Let me know whether the scenario is as per this.

With regards

Balaji.J

[Former Member]

Hi,

Thanks for your valuable reply.But i found that there was an entry there in PP Meter field in various tab in iq03. There if i remove the that entry then the problem gets solved. Please give your opinion and your suggestions.

Thanks and Regards

[Former Member]

Dear Vash,

The pp field in the meter indicates the meter might be a prepaid meter, which would be configured at the Device category level. Can you pls check with the following t-codes whether any data is existing..

EPREPAY and EPREPAYFREE. If possible send the screenshot of those two transaction codes to me at my inbox which is balaji85 attherate yahoo dot com

With regards

Balaji.J