2011 Aug 30 7:58 AM
Hello Friends,
I could not understand the flow of meter reading (which is entered by T code EL28) to Input operands in billing schema. Can somebody explain me the flow?
Thanks
Harshal
2011 Aug 30 9:04 AM
Hi,
This is bascially governs by the Permissibility i.e. in case of Register Permissible Rate the MR data is picked up from the relevant device of the attached installation and then value is transferred to Register Operand based on the UOM.
For e.g. if you enter the MR data in EL28 and then try to bill that following things happen: while the billing engine runs rates are executed sequentially. Now when a rate is executed the permissibility will guide to identify how the rate will get the initial data. After that this data will be transferred to Register operand which will be again driven by the UOM.
Regards,
S
2011 Aug 31 7:31 AM
2011 Sep 02 6:30 AM
2011 Sep 02 3:20 PM
Hi Harshal,
Rate Type is associated at device level to a register, now for this Rate Type a Rate is determined which is used in the Schema. When a meter reading is entered, it gets transferred to that Rate through Register Operand used in that corresponding Rate. This way the Meter Read goes to the Input operand in Billing Schema.
Let me know if u have any questions.
Thanks,
Rakesh