configuring number ranges for ADRV and ADRVP

[Former Member]

I'm doing configuration for number ranges in ECC (implementing IS/U) on a client site and while working with ADRNR in SNRO, I've also come across ADRV and ADRVP.  What are these used for and are they available in a config node inside the IMG?

[william_eastman]

Keith:

ADRV and ADRVP do not have number ranges - they use the same values from ADRC for the address numbers.  You would not configure anything for them.

I see now your question.  have to think about this.

regards,

bill.

[Former Member]

Thanks Bill (hello BTW) - I got handed someone else's cookbook and I recognized the other NR objects, but not these.  Nor could I find them in the IMG...

[william_eastman]

Hi Keith:

I can only find usage of these when SD is in play.  Not to say they aren't used otherwise, but not normally valid for ISU scenarios.

regards,

bill.

[Former Member]

So I'm correct in saying I can ignore these NRs for an IS/U only implementation, right?

[william_eastman]

Sounds fine - or you could set them up with 01 values just to be safe

[Former Member]

Which actually leads me to another question, is there a good way of knowing when a NR must have a value of "01" versus creating our own NR value?  

[william_eastman]

also 'should' not matter.  my approach would be 01 as base default unless i can assign the range somewhere else in configuration.