2013 May 29 6:43 AM
Hello experts,
I want to use command group for street lights. for this i have created command and command group in isu.
Now i want to know how i will use these command group?
Please suggest me in detail.
Regards,
Priya
2013 May 29 3:50 PM
Priya,
You can assign the command groups to the devices you create using IQ01.
Regards,
Yuvi.
2013 May 30 4:31 AM
Hello Priya,
A command group is a group of several commands. Say a command is a signal sent out by a utility company that causes an audiofrequency ripple-control receiver to trigger a switching procedure. As in case of your example, in the case of street lighting, a command group may consist of the commands ”switch on,” ”reduce power,” and ”switch off.”
Go to the Device , select the tab "IS Data", in below screen select tab "Group", here you can assign the Command Group.
Hope this helps you out.
Regards
Sachin
2013 May 30 6:05 AM
Hello Sachin,
Thanks for your reply!
Pls suggest me what should be Device type if i use command group.
I hope this could be assign to device category. because when I go to device-->IS data-->group, this command group option is not active here.
Regards,
Priya
2013 Jun 05 5:39 AM
Create as a Relay (KOMBINAT = T)
The command group can be maintained on creation (IQ01) or in general by Device Modification (EG42)
Alternatively can be declared on installation (EG31) or timesliced when installed (EG42)
2013 Jun 06 12:46 PM
Hi deniel,
In IQ01, command group field is not active.
Which type of device category i should create? As u told RELAY, there is no device category in EG01 like this.
Please suggest.
Regards,
Priya