- SAP Community
- Groups
- Industry Groups
- SAP for Oil, Gas, and Energy
- Discussions
- PM Vehicle Equipment as Transportation Unit
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2011 Feb 04 9:51 AM
- SAP Managed Tags
- Oil, Gas, and Energy
Hi, as part of IS-OIL module i have created transportation units and i've assigned them with pm vehicle equipments.Everything goes by the book until u press the button "equipment display" into the screen of transportation vehicle and a message:
Requested function EQUI is not available here Message no. V0104 appears.Any idea??
I've already made the same post into the Asset Management section but i took no response so i made the same post here..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2011 Apr 07 3:23 PM
- SAP Managed Tags
- Oil, Gas, and Energy
I think you are config is fine but likely you are missing entry for this program for EQUI from T185F table. Check with the technical team if this is from a BC set or if OSS notes are available.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2011 Apr 07 3:23 PM
- SAP Managed Tags
- Oil, Gas, and Energy
I think you are config is fine but likely you are missing entry for this program for EQUI from T185F table. Check with the technical team if this is from a BC set or if OSS notes are available.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2011 Jun 10 3:40 PM
- SAP Managed Tags
- Oil, Gas, and Energy
Dear ashutosh joshi ,
Thank you for your response.
i checked T185F table but i can't find the missing entry.Any ideas?
