SAP for Oil, Gas, and Energy Discussions
Connect with fellow SAP users to share best practices, troubleshoot challenges, and navigate the evolving energy landscape. Join the conversation today!
cancel
Showing results for 
Search instead for 
Did you mean: 

IS Oil Oil calculator

Former Member
0 Kudos
554

Hi

I'm using conversion group 534b for oil conversions .And while trying to use O3QCITEST , oil calculator I'm getting an RFC error . Error code : o3 388 .

Error Message : RFC destination QCI_SERVER does not exist.

Can u please help in identifying the solution for the same .

Rgds

1 ACCEPTED SOLUTION

Former Member
0 Kudos
213

Hi,

This is a generic error which is displayed when you do not maintain the QCI RFC server details.QCI calculation can be called using various methods out of which one is RFC server call.

You need to first check in SPRO customizing uder IS-OIl Downstream HPm module QCI for conversion routines call setup. If the routines are using a functional call or system call an RFC server call is not required.

If the function call is via an RF than you need to mention the RFC server details or change the customizing to call the external astm routines via a system call.

Do let me know what your customizing contains and i shall be able to help you better.

Regards,

GAurav

View solution in original post

2 REPLIES 2

Former Member
0 Kudos
214

Hi,

This is a generic error which is displayed when you do not maintain the QCI RFC server details.QCI calculation can be called using various methods out of which one is RFC server call.

You need to first check in SPRO customizing uder IS-OIl Downstream HPm module QCI for conversion routines call setup. If the routines are using a functional call or system call an RFC server call is not required.

If the function call is via an RF than you need to mention the RFC server details or change the customizing to call the external astm routines via a system call.

Do let me know what your customizing contains and i shall be able to help you better.

Regards,

GAurav

0 Kudos
213

Hi

Thanx . I checked the config under - SPRO - IS OIL Downstream - HPM -QCI Configurations-->Define function groups and function module settings .

The conversion group has been attached with FM name and FM Subroutine and has FM import and FM export mentioned .

What should I check for ?

Regards