SAP for Oil, Gas, and Energy Discussions
Connect with fellow SAP users to share best practices, troubleshoot challenges, and navigate the evolving energy landscape. Join the conversation today!
cancel
Showing results for 
Search instead for 
Did you mean: 

Additional UOMs or the ASTM parameters not calculated for Outbound Delivery

Former Member
0 Kudos
361

Hi there,

This question is specific to IS OIL. Could any one please let me know what could be the reason for the Problem described below.

I have created a Sales order on a IS Oil Materil. On successfull craetion of the sales order I created a Outbound delivery for it. Now the problem here is Am not able to see any additional Unit of Measures calculated. (ASTM Parameters)

I wanted to know why the the additional Unit of measures were not calculated. Is there any config Am missing ?

Please keep in mind that I have already maintained the O3 defaults for the given Plant and Material And cmeth = 1.

Answer to this question will be highly appreciated.

Thanks

Madhu.

1 ACCEPTED SOLUTION

Former Member
0 Kudos
241

Hi Madhu,

Did you create the material on views Oil-specific data, and assign the conversion group, UoM group to the material?

Besides, you should link the Reading group to the conversion group in Conversion group maintenance to determine how many parameters would be used in you QCI screen.

Hope this may help.

View solution in original post

2 REPLIES 2

Former Member
0 Kudos
242

Hi Madhu,

Did you create the material on views Oil-specific data, and assign the conversion group, UoM group to the material?

Besides, you should link the Reading group to the conversion group in Conversion group maintenance to determine how many parameters would be used in you QCI screen.

Hope this may help.

Former Member
0 Kudos
241

Hi

if the ASTM default is maintained and the material master is having conversion group. The only explaination of the system behavior would be you are not entering the storage location in the Delivery doc. If you are not meant to enter it, then it is pretty much standard SAP will not do th eqty conversion, no matter you only maintain the ASTM default at plant level only.

Edited by: KamalAnuar on Nov 24, 2010 8:17 AM