SAP for Higher Education and Research Discussions
Spark conversations about student engagement, research optimization, and administrative efficiency using SAP in higher education and research. Join in!
cancel
Showing results for 
Search instead for 
Did you mean: 

Process-Independent Audits. URGENT

Former Member
0 Kudos

Hi,

I've been testing the degree audits. I've already developed subrequeriment conditions (BAdIs) and I've defined subrequeriments and auxiliary conditions, and assigned parameters to such conditions. Well, by trying to execute the degree audits to a student (Tx <b>PIQAUD_MP_CS</b>), system shows a global message about the status of the execution. I need to check the results (i. e. Filled, Not Filled) for all subrequeriments. I put as hard code <b>BREAK-POINT</b> in the code of the BAdIs, and it doesn`t work. I'd like to know, is there another way to see the result of the degree audit for each requirement, once the system runs the audits?

Thanks a lot

JORGE ROJAS LOPEZ

1 ACCEPTED SOLUTION

0 Kudos

Hello Jorge,

The transaction that you are using PIQAUD_MP_CS is actually for mass processing, so if you want to execute the audit and view the result independently for each student, you can use the BSP application <b>PIQ_AUDIT</b>.

With this BSP application you can create requirement profile and execute audit run for all configured modes (official/simulates//test).

Thanks and Regards,

Kasi Raaman.R

View solution in original post

1 REPLY 1

0 Kudos

Hello Jorge,

The transaction that you are using PIQAUD_MP_CS is actually for mass processing, so if you want to execute the audit and view the result independently for each student, you can use the BSP application <b>PIQ_AUDIT</b>.

With this BSP application you can create requirement profile and execute audit run for all configured modes (official/simulates//test).

Thanks and Regards,

Kasi Raaman.R