No NC codes logged using Workcenter POD(message 18117)

[former_member852327]

A non-conformance code and group were created.

But the following error is always returned when a NC is logged. Same error for the default NC codes.

[former_member828952 · Accepted solution]

Hi Thomas,

did you click on "Add" before you clicked on "Done"? Only "Add" is adding a NC, "Done" is used for triggering the disposition to NC Routing if it is configured.

If you don't want to use 2 buttons, you can enable a combined "Add/Done" button in the POD Designer for this plugin.

Tobias

[former_member852327 · Accepted solution]

Thank you,

That indeed worked!