Component Extension 6.0 SAP EHSM - Std config missing

[Former Member]

Hi Everyone ,

I need some help in EHSM. We have installed EHSM 6.0 in our system . I checked the IMG nodes in system to see if standard configuration values are present.

I could see entries i.e standard config values under many of the standard configuration nodes itself is missing.

For example

Entries in Process definitions in Foundation

Entries in Print and interactive forms - Forms,Form groups etc

Entries for all sub nodes of Actions and controls

Location types

Incident recording basic info entries

Most of the standard configuration entries are missing . Above are just some examples .

Component extension EHSM is new for me.So can somebody let me know if something has to be done to make sure all the standard configuration values are copied/present in the system ?

Thanks

[former_member215646 · Accepted solution]

Hi Sunganth,

The default configuration for SAP EHSM is provided in BC-Sets which you need to apply.

SAP provides all scenarios which can be implemented with SAP EHSM in the Solution Manager. Solution Manager content contains documentation, BC-Sets for each scenario, related reports and transactions. Especially if you have no experience with SAP EHSM it is recommended to use SAP Solution Manager for the installation.

A good starting point is the SAP EHSM Master Guide which is available on the Service Market Place. The Master Guide is linked in the SAP Help portal for SAP EHMS: Component Extension 6.0 for SAP EHS Management – SAP Help Portal Page

Best regards,

Andreas

[Former Member]

Sunganth,

You will need to copy the entries from client 000 to your active client using the transaction SCU0.  This will need to be done for all customising entries you need for the components you are using.

Regards,

Michael