New Button Feature Config

[gilormalong]

HI, we have opened a ticket and had one of the SAP specialist, Mahnaz look into the configuration for the color scheme on the new button feature and still have issues with the button aopearing disabled in the carousel until the user hovers over it. See attached. Mahnaz suggested the following paremeters for config but it did not work at all to change anything except the font color. Is there specific parameters for the new buttoin feature for link tiles ion the carousel that we need to address to change the color scheme or make this appear enabled? Ticket number is: 868097 / 2020 and attachments:

button-tile-grayed-out.jpg

changed-color-but-still-only-shows-with-hover.jpg

button-with-hover-color.jpg

Config suggested that didnt work is: help-focusBg=0,94,184&help-bubHeadBgCol=0,145,218&help-uiBg=64,134,202&help-accentBg=0,51,141&help-accentFg=0,94,184

Any suggestions are appreciated.

[MichaelSzmrtits]

Hi Gilorma,

the information that the button is controlled by the parameter accentBg should be true. But other elements are controlled by this parameter as well.

But I think that there are additional dependencies to the other defined colors, which finally influence the appearance. So in some cases it seems that there is a little bit of a try and error approach needed to get good results out of it.

Did you try to set the value of accentBg to 250,250,250 (white). In my test I got good results without changing your CI in a big way and without a grayed out button. See attached screen with a comparison (left your settings right my settings).

If this is not helpful at all, I would suggest to reach out to your assigned CEE to recheck your incident 868097 / 2020.

In addition it could be helpful to send the product mgmt. team an improvement request via the influence portal: https://influence.sap.com/sap/ino/#campaign/1740

Hope that helps, best regards, Michael

[gilormalong]

I will have the developers try your suggestion for the accentBg and see if that resolves it.

[MichaelSzmrtits]

Hi Gilorma,

today I have also triggered an internal improvement request on this. After some tests and talks to our PM my understanding is that the button will be influenced mainly by the parameter Accent Background Color. But with a reduced or lighter accentuation as defined. In my opinion, the button should be defined by the parameter UI Foreground Color (Frame & Font). The fill should be dependent on UI Background Color. But for any reason it isn't so at the moment. So I assume that our support team wil nowl perform additional tests and will contact you again. Hope we can achieve here an improvement for you and your corporate design. Best reagrds, Michael