How to overcome from error messages after adding new simulation template ?

[maqsoodsyed1]

Hi Community,

I quickly recorded a very short video, modified the images on the start and end pages, and put this simulation as the default template in order to make a simulation template, but now I am facing two problems.

1. After performing Finish Editing on the Default folder, an error message is displayed.

2. When the workarea is synced after adding the short and description content, the application displays an error message.

3. Despite below error messages I’ve attempted to create new simulation(I shouldn’t do ideally) using default created template but the simulation ignores start and end page.

Is it recommended to replace images on start and end pages?

What are the dos and don’ts while creating simulation template?

Please guide further.

Best Regards,

Maqsood Syed

[DirkManuel · Accepted solution]

I don't know how you "modified the images" but typically that error is because you have changed something in the file system - SAP Enable Now has a checksum to check whether any of the files have been corrupted. I'm guessing it is objecting to your template. Right-click on that and select Refresh Object. You'll probably also need to do the same thing with your existing simulations created from this template, before you can save them to the server.

I did an entire video on creating Simulation 'Templates' and the options available. See here.

[maqsoodsyed1 · Accepted solution]

Thanks Dirk.

The video recording related to simulation template was very helpful.

One quick question here…What if someone wants to learn SAP Enable Now from beginner level to Expert level?

Does https://www.youtube.com/c/EnableNowExpert site facilitate in imparting training?

Please advise!

Best Regards,

Maqsood Syed

[DirkManuel · Accepted solution]

As it happens yes, I do offer training (self-paced eLearning, developed and delivered in SAP Enable Now) - see training.enablenowexpert.com.