Highlight Frame can´t be edited

[former_member728004]

Hello,

in the simulation preview of a step a do see a red frame.

See following screenshot

It is not possible to edit this red frame in the working area on the right side as this frame is not available there. On the left below the screen you see there is not highlight frame added to this step. Where is it coming from and how can I change position of that frame?

I´d like to change at least position of the frame as this is ending in the word training material as follows, which doesn´t look user friendly.

Any recommendations what can be done by me to change that? I´ve already copied the whole step. Doesn´t matter it´s always coming back.

Thanks a lot and have a nice day,

Kind Regards,

Ute

[DirkManuel · Accepted solution]

Is it on the previous Screen which is hidden from the documentation?

[DirkManuel]

@utebeckers If you want to have the screen shot under the same heading in the Training Document, just deselect the Use Title as Heading property for the Screen macro. (I assume you have Headings From set to Screen in the Document definition.)

[KristinaKunad]

Hi Ute,

I can see that the step and the screenshot don't have a name. This might hint that something went wrong during the recording. Did you try to re-record that same step?

I believe that this is a glitch in the recording. You can try to check if this rectangle is visible in other modes as well, especially in the documentation mode.

You can also check the .png of the screenshot in the folder structure and see if it appears on there or not.

Hope that helps!

Take care,

Kristina

[former_member728004]

Hello Kristina, thanks for your answer. We delete name of some screenshot when we want to have them in the same chapter within the training document (word-version) instead of getting an extra chapter for each single screenshot.

That how we do it as of now. Maybe there is another way which you recommend.

Thanks and have a nice day,

Ute