FTE Reset to 0 When Operator Changes Job Info for Employee

[vanessilva]

Hi, experts!

The question on situation is, employee was transferred for a new position FTE=1, however in a pending workflow the FTE change to 0, so which causes is? Any Tips?

Best regards!

[harshithap]

Hello Team,

FTE automatically updates to 0 during the data change in the Job Information.

Standard hours has been enabled in Job Information element. There's a rule which defaults the value to 1.

Yet, the FTE changes to 0. Any idea?

Thank you!

[karenperez]

Dear vanessilva,

Thank you for your post/question.

How do you have the FTE calculation set up? By standard, it is calculated If the standard-hours field is enabled in the configuration. The system will calculate the FTE based on Job Info Standard Hours Vs Object Standard Hours (Legal Entity or Location or Job Classification) depending on configuration.

Check your configuration because this may the cause.

Thank you.

Best Regards,

Karen Perez

[vanessilva]

Thank you Karen!