explanation and mouse action bubbles

[LA0]

Hi, in practice mode I am getting the position of my explanation bubbles exactly as I set them in demo mode. However, this is not the case for my mouse action bubbles where I have to readjust positions ...Is there any way to fix this ? Thanks for the tip!

[Wallace]

I thought by default the action bubbles on practice were centered in the screen? And depending on where the action is, you may have to move them to keep them from masking the content?

[DirkManuel · Accepted solution]

Check Authoring Settings > Recording > Simulation / Documentation category > Practice Bubble at Element. This is likely deselected (it is by default, as Wallace says). Explanation Bubbles are handled separately (and you may have Use Demo Bubble for Practice selected which will always position it in Practice mode in the same place you see it in Demo mode (because it's the same bubble).

[LA0 · Accepted solution]

Thanks, is this supposed to change the existing recordings too ?

[DirkManuel · Accepted solution]

No, It's a Recording setting so only applied at recording time. However, you could select all macros and change the position of them all to the same thing - you'd probably need to change a few of them, but at least it would reduce some of the work. Else just go through each macro, copying the Demo bubble position and pasting this onto the Practice bubble position.