An error occurred in the application dynamic type conflict when assign references

[Former Member]

Hi,

an error screen appears when a candidate is selected and click on Assign to various tabs of a requisition.. ( for instance  Screening and Ranking) This happens especially in the requisitions with large number of applicants. Any thoughts?

Thanks,

Lucius

Error :

“ We are sorry !

An error occurred in the application dynamic type conflict when assign references

[NicoleGeischnek · Accepted solution]

Hi Lucius,

And that's just happening if there is a hughe number of assignments?

Regards,

Nicole

[Former Member · Accepted solution]

Hi Nicole,

The error occurs in almost all the requisitions but especially in requisitions with large number of applicants.

BR,

Lucius

[NicoleGeischnek · Accepted solution]

Hi Lucius,

Could you please add the whole error message and also the SLG1 entry (if you get one)?

Regards,

Nicole

[Former Member · Accepted solution]

HI Nicole,

“ We are sorry !

An error occurred in the application dynamic type conflict when assign references.

If the problem continues to exist, please contact support ...

That is the whole message..

BR,

Lucius

[NicoleGeischnek · Accepted solution]

Hi Lucius,

Could you please add the ST22 dump you probably get for that error?

Regards,

Nicole

[Former Member · Accepted solution]

Hi Nicole,

ST22:

"

Error analysis

    An exception occurred that is explained in detail below.

    The exception, which is assigned to class 'CX_SY_MOVE_CAST_ERROR', was not

     caught in

    procedure "ASSIGN_TO_PROCESS" "(METHOD)", nor was it propagated by a RAISING

     clause.

    Since the caller of the procedure could not have anticipated that the

    exception would occur, the current program is terminated.

    The reason for the exception is:

    It was tried to assign a reference to a rereference variable using the

    'CAST' operation ('?=' or 'MOVE ?TO').

    However, the current content of the source variable does not fit into

    the target variable.

    source type: "\CLASS-POOL=/1BCWDY/1DQFDPFOHPITYJV2UMC6\CLASS=CLF_COMPONENTCONTR

    OLLER_CTR"

    target type: "\INTERFACE=IF_WD_CONTROLLER"

"

[NicoleGeischnek · Accepted solution]

Hi Lucius,

That's solved with note 1807824.

Regards,

Nicole

[Former Member · Accepted solution]

Hi Nicole,

thank you very much for your support..

BR,

Lucius