Number ranges

[former_member425985]

I am trying to change the number ranges for one of the object through SNRO(50000000-69999999).Presently its close to 69999999.

And when I go to SNRO and press change interval button, I am getting a pop up as "Make repairs in foreign namespaces only if they are urgent". I am not sure how this will affect my system. All I am trying to do is to increase the range from 69999999 to 999999999.Just replace 6 by 9 in change.

Please let me know if I may hit any conflicting situation due to this. Your expertise on this is highly appreciated.

[jogeswararao_kavala]

Which object you are trying to expand the range?

[former_member425985]

COPA_IST

[jogeswararao_kavala]

I think you should use tcode  KEN1 for modifying this number range.

[former_member425985]

Thanks, yes I can use KEN1 directly entering directly operating concern. But if I go thru SNRO, system will ask for number object then takes me to KEN1 screen where in I have to enter operating concern and change the interval.

My question is what will happen if I ignore ,message pop up "Make repairs in foreign namespaces only if they are urgent". This I am getting once I enter  my number range object and press change button. I hope there shouldn't be any consequences if I just press enter and continue but want to be sure as I have never changed or added to the existing number range

[jogeswararao_kavala]

Hello Pramod,

• See one such pop-up with message here, I get during the use of few enhancements which I work with. "Carry out repairs in non-original system only if they are urgent". It looks similar and is not critical.
• However, you should contact your BASIS (Security) team and get clearance, as the Help (?) Procedure below suggests in your case.

---------------------------------------------------------------------------------------------------------------

Diagnosis

The object being edited is in a namespace reserved for objects belonging to SAP or another software producer. This system is supplied with this namespace.

System Response

The function continues.

Procedure

Only perform urgent repairs and only after consulting with or on instruction from the owner of the namespace.

--------------------------------------------------------------------------------------------------------------

Good luck

KJogeswaraRao

[former_member425985]

Hi J.Rao,

Thanks for your input.I think I am suppose to use KEN1 instead of SNRO.Your input was helpful.Let me try though.

http://scn.sap.com/message/16763127