Missing selection object Z_PROP_PL_10_NI in “How to proportionate data”

[takshin]

Hi Experts,

I am implementing the proportional integration configuration following SAP’s “How to proportionate data” guide. The guide references a selection object named Z_PROP_PL_10_NI, but this selection is not present in my system and the guide does not show the exact filter definition. The selection is used by the proportionate/reclassification step to pick which posting‑level lines should be proportionated.

System: S/4HANA Group Reporting (on‑premise). I followed the guide up to the point where the selection object is referenced in the reclassification/proportion task configuration.

Attaching Screenshot for the same page no18.

Thanks in Advance!!

Takshin

[birgit_vaders]

Hello Takshin,

you are right the screen shot is not attached in the document but based on the description on page 18 the content of the selection Z_PROP_PL_10_NI is almost described,
• proportional unit (=> exampleBVP006)
• all values from FS Item 317000 posted until PL 10 (FS item 317000 is the special ANI FS Item which was excluded from the posting of sequence 010)

I'll insert the screen shot in the how to paper. Update in the note appr. next week.

Best regards

Birgit