Grouping Fixtures and Fitting Characteristics

[malalex]

Hi there,

           Newbie question:  where about REFX saves the Grouping for fixtures and Fitting characteristics? Following SAP help I should I go to IMG >> Master Data -> Usage View >>Building >> Specify Structure of Fixt./Fittings Characteristics Independent of RLR , but there I cannot see any structure setup altought I can see there is one when I am trying to add a new characteristic to an AO.

This is what I see in the "Specify Structure" , I was expecting to see the existing groups there but it is empty.

Thanks in advance for any guidance,

Regards

[andre_nakratzas · Accepted solution]

Hi Alex,

See the example below and the corresponding config to recreate this:

Config:

Cheers, Andre

[malalex · Accepted solution]

Thanks Andre! much appreciated!