GRC 10.1 SAP 19 Access control and SFEC integration - Connection type error

[former_member226284]

Hi All,

We are GRC 10.1 SP 19 and trying to connect SF with access control directly.

I am following the steps as per the note 2538932 SF integration.

I have installed SSL certificates and created HTTP connection successfully.

Now I have to create a connection type SFEC as I cant see it, I am getting the below error!!

My question is : Does connection type SFEC should be a default one for SP19, if not how can I create a new one and what will be class name associated to it.

Thanks

Trilok Kola.

[former_member226284 · Accepted solution]

I am closing this thread, Issue has been resolved with SAP note 2682977 - SF connection type ABAP class.

Thanks

Trilok

[former_member226284]

Hi Madhu,

I am able to save the new connector type I have created now. What would be the ABAP class associated with this SFEC connector type?

Thanks

Trilok Kola

[former_member226284]

Hi Madhu,

Thank you for your response. Eventhough it is a warning message this is not allowing to save.

So you are saying SFEC connection type wont be there in SP19 by default? It has to be created by us?

Thanks

Trilok

[madhusap]

Hi Trilok,

It's not an error message. It's just warning and you can press Enter button and proceed to save the changes.

[former_member226284]

Hi madhusap , I would request you to check on this and let me know if you have gone through this while integrating SF with GRC10.1 SP19.

Thanks

Trilok Kola