BPC Planning sequence working in Debugging but not through Forms.

[vimal]

Hi Everyone,

We have a scenario in BPC module, planning sequence is working fine when we debug it but when we run it without debugger then it gives us error.

So we have written logic in AMDP class and the class is consumed by Planning sequence . So when execute planning sequence(through RSPLAN) without debugger , it gives us error but when we run it by putting debugger in AMDP class it works fine. Below is the screenshot of error(These errors only come without debugging).

Any suggestions from anyone if such kind of scenario is faced in BPC earlier and what can be possible reasons. Any OSS notes if available because this is not a standard behaviour ? Or can it be an issue with Buffer , if yes then how to clear the buffer ? Any programs ?

[VXLozano]

Usually, when something works in debug but does not in normal mode, there is something about timing. Maybe there's an update task launched, but your program runs too fast and reach a point when the update task is not finished yet and then it "breaks".

I hate delays, but...

[vimal]

No , it's not the case...

[FredericGirod]

What about putting a break point on the message number corresponding to the first error ?