Where in SAPLV69A to debug to analyze incorrect percentage calculation of a pricing condition

[anna_ha]

Hi colleagues,

one condition type is pulled correctly as 10% in one sales document. Customizing looks fine.

However, the condition value is calculated not as 10%, but as 100%. If I correct it manually to 20%, it calculates it as 200% instead.

Where can I find where this extra "0" comes from into the formula behind the percentage calculation?

In SAPLV69A ?

n the screenshot below, it should be 50 EUR instead of 500EUR. So it calculates 100*500/100 instead of 10*500/100

[raymond_giuseppi · Accepted solution]

You have usually some buttons on the condition display table to

• Display Condition Detail (or double-click)
• Read condition records
• Analyze the conditions (pricing log)

(or add ABAP Development to your tags)

[anna_ha · Accepted solution]

Thank you Raymond for the update. I have tried all three options.

[Lakshmipathi]

Did you check KONV-KWERT ? Double click that condition type and see what you see under Conditions Item detail. Two tabs will be there; viz. Condition values and Control which will give an hint how the values are calculated.

[anna_ha]

Hello @Lakshmipathi Ganesan sir, thank you for a prompt response. This is how I knew that it calculates the actual value by multiplying with 10*. Because the 10% of highlighted 500 Euro condition basis should have been 50 Euro only.