Storage Unit Number same for full in all processes

[NurlanJ]

Hi Experts,

Is it possible to link a storage unit number to a material in WM module? That is, after the material enters the warehouse (GR to 902 storage type), it should be used under that one storage unit number until it is issued.For all bin to bin processes with the same storage unit number.

BR,

Nurlan Jafarzade.

[MohdRashid · Accepted solution]

Hi

Could you try with hu pick control in storage type and movement type. and select option 1

•  the issuing handling unit is proposed as the destination storage unit during confirmation of the TO item and the HU copy indicator is set.

I hope it will full fill your requirement 

Regards

Rashid Khan

[NurlanJ · Accepted solution]

Thanks for your reply .We already did this customization but we have the problem when we transfer the material partially. LT10 with full quantity is working. Is any suggestions for partial movements do you have?

[MohdRashid · Accepted solution]

It works on logic. in standard when you do partial movement it will create new Su. It is standard behaviour. Remaining SU will be same as it was earlier. As per my knowledge it is not possible