Schedule lines are generating with decimal values for dependent requirements with MRP. for UOM PC

[former_member211676]

pc3.jpgpc1.jpgpc2.jpgHi Experts,

I am facing below issue when MRP for one of our plant.

When we execute MRP system generating schedule lines with decimal values for UOM PC for the dependent requirements. There is no changes in UOM PC in configuration. Could please let me know the reason if any one faced the same issue.

Regards

Chennakeshava Rao

[former_member261747]

Hi

Please check field "Decimal pl. rounding " in Unit of Measurement T-Code CUNI .It should be blank.

BR

[rupesh_brahmankar]

Hello,

Is it a decimal place or just a comma?

I don't think there is a decimal, it's a full quantity 60 925 PV

Please check your decimal notation setting for your user profile in SU3 default tab.

Set it to Y 1234567.89 then log off and login again and then check the quantity in MD04.

Best Regards,

R.Brahmankar

[former_member211676]

Hi Rupesh,

Thank you for the immediate reply and I have same default profile for my ID as attached and we are facing issue with this decimal when we transmit to third party systems. Could you pls help here.

Regards

Chennakeshava Chinnam

[rupesh_brahmankar]

Hello,

Is that transfer through the RFC user then check the setting for RFC user too

Maybe you need to check with your technical team about the third party transfer process and logic of read and write of quantities.

Best Regards,

R.Brahmankar

[former_member211676]

Hi R Brahmankar,

After analysis we found that the decimals are generating through MRP for the requirements for UOM PC. Please find attached snap for pegged requirements. Please suggest what may cause this issue.

Regards

Chennakeshava Rao

[rupesh_brahmankar]

Hello,

I don't think these requirements are in decimals, if your unit of measure PC is defined without decimal then MRP will always respect it.

Best Regards,

R.Brahmankar