cancel
Showing results for 
Search instead for 
Did you mean: 

Regarding Crystal report parameter from and to.

Former Member
0 Kudos
50

hi.

I am having one requirement ie.

Normally we are giving..i.e

We are using parameter in Sap b1 like Docentry

Based on this one Docentry the data will fetch from the data base and it will shows into the sap crystal reprot

suppose Ex Docentry = 3 then it will show the data.. then

but ring now what i nee dis  Docentry from and to

fromdocentry = 1

todocentry  = 5

so, 1,2,3,4,5 five documents should be generate one by one in crystal report in single crystal report not 5 pdf files single pdf should have 5 doc entries

Is it possible how can i do it.

how can i do it...

Accepted Solutions (0)

Answers (4)

Answers (4)

julie_jamieson2
Active Contributor
0 Kudos

Try changing the parameter type to allow Range to see what that does. I haven't tried this with the SAP SP tokens.

You may need to create your own, as this will run as a report, not a layout?

Former Member
0 Kudos

I got the solution...

At new page before i put  the code...pagenumber = totalpagecount

at new page after i put the code. ...pagenumber =1

former_member188586
Active Contributor
0 Kudos

Hi

$riniva$ Rachumallu

please Follow above image steps, you get the Out put..

  Thanks Regards

     Andakondaramudu

former_member205766
Active Contributor
0 Kudos

Hi

I think it is not possible from Crystal Report but below discussion indicates it is possible through some Crystal Report SDK tool.

With Regards

Balaji Sampath

kothandaraman_nagarajan
Active Contributor
0 Kudos

Hi,

I don't think it is possible.

Thanks & Regards,

Nagarajan

Former Member
0 Kudos

I seen some where...but i dont know how....