Recurring Inspection - Not allowing results entry

[jessica_martinez]

I am setting up recurring inspections. Here are the steps I have completed.

1. Added Inspection type 09

2. Maintained Inspection Interval

3. Confirmed Next inspection date is populated

After doing these things, I ran QA07 to inspect stock at lot creation. 

**The material successfully goes into QI but I CANNOT enter results in QE51N**

Am I missing a step? There is an inspection plan created, why is it not being triggered?

Do I need to create a new inspection plan with a different control key?

Many thanks

Jessica

[HermanAlkemade · Accepted solution]

Hi Jessica,

An inspection plan with usage 9 (material check) should be available for the material.

By default the inspection type 09 is configured with usage 9 (you can check in inspection type configuration).

regards, Herman

[jessica_martinez · Accepted solution]

Thanks Herman, I looked in config and also had to change the control Key in the inspection plan