cancel
Showing results for 
Search instead for 
Did you mean: 

PP-QM INTEGRATION

0 Kudos

I AM USING INSPECTION TYPE 3 AND LOT NUMBER NOT RAISING AUTOMATICALLY

ILNC- Inspection lot not created

Navigation not possible because no entry exists

Message no. C2098

Accepted Solutions (1)

Accepted Solutions (1)

former_member42743
Active Contributor

Config:

Quality Management-->Quality Inspection-->Inspection Lot Creation-->Maintain Number Ranges

The number range is assigned to the 03 inspection here:

Quality Management-->Quality Inspection-->Inspection Lot Creation-->Maintain Inspection Types

Answers (2)

Answers (2)

rupesh_brahmankar3
Active Contributor

Hello,

Does production order status is release REL?

This could be also due to release rejected of production order.

Status ILNC - make sure you have maintained the QM data in your material master properly.

Please check if EXIT_SAPLQPL1_005 in enhancement QAAT0001 is active in the system.

Best Regards,

R.Brahmankar

former_member42743
Active Contributor
0 Kudos

I suggest you get with an APAP'er to debug. Very hard to trouble shoot something that doesn't exist.

The one thing that comes to mind that might cause that is a number range issue. Make sure inspection type 03 is assigned to a number range and the number range assigned hasn't run out of numbers.

Craig

0 Kudos

where is setting for automatic number range creation for type 3 inspection