Output device in condition record

[murphybs]

Hello,

we setup a condition record for sales order confirmation and we have to put in a printer here.

Is there a way in the condition record to tell the system to use the printer from the user master record instead to put a printer in the condition record?

I know the way to put in LOCL as printer, but the question is if there is another way.

[jignesh_mehta3 · Accepted solution]

Hello Bernhard,

Please check your Output Type Configuration in V/30.

Check if, Under Tab - Print, the Print Parameter is set to User.

Also refer "SAP Note 1461071 - User defined printer not populating output type in SD" for sequence of Printer search in SAP Standard.

Thanks,

Jignesh.

[murphybs · Accepted solution]

Hi Jignesh,

that sounds not so bad. I will check with the team an come back if these works for us.

[Lakshmipathi · Accepted solution]

When you create a discussion and start adding additional information as asked by the members, please add the same under Comments and not under Answer as you were not answering but sharing additional information. Also, when you add under comments, a mail will be triggered to who you respond. By the way, I have converted your above Answer to Comment

[murphybs]

Hello,

thanks works as expected.

[Neeraj_Jain]

Hello schoeberl_b,

Go to Menu----->System----->User Profile------>Own Data

Click on "Defaults" tab and set output device in Spool Control and check.

Confirm if it's works for you.

Regards,

Neeraj Jain

[murphybs]

Hello,

i know where i can set the printer in the user master record.

What i want to know if there is a way to set a placeholder in condition record in the output device.

So that at the time the message is created it chooses the printer from the user master record.

[Lakshmipathi]

When you create a discussion and start adding additional information as asked by the members, please add the same under Comments and not under Answer as you were not answering but sharing additional information. Also, when you add under comments, a mail will be triggered to who you respond. By the way, I have converted your above Answer to Comment

[Neeraj_Jain]

Hello schoeberl_b,

Just to update have set parameter "S-User parameters" under Print Tab of V/30 and maintain printer in SU3 (User Profile).

Actually earlier had used this functionality that's why I answered to maintain user profile but missed to update settings of V/30.

It works fine.

Thank you jignesh.mehta3 for highlighting SAP Note-1461070.

Regards,

Neeraj Jain