Measuring documents posting -reg

[Former Member]

Hi,

We have created 6 measuring points for the measurement and readings entry for an equipment

we have created a entry list through IK31

when we post the readings of all these 6 measuring points through IK34 , system is posting one measuring document for one measuring point -reading

if this is standard behaviour of the system how can we make it post only one document for all the 6 readings i enter at the same time

issue is if for each measuring point -reading combination one document is posted means based on huge no.of readings and entries measuring documents number ranges are affected

cant we set the system such that for a set of measuring points and their readings entered at the same time , one document is only posted ?

regards

madhu kiran

regards,

madhu kiran

[Former Member · Accepted solution]

Madhu,

Every reading for one measuring point would create a Measurement Document. IK31, IK34 to make the user to create a group to enter Measurement readings in a single screen...

Babu

[Former Member · Accepted solution]

Hi,

If i enter one reading for a measuring point wrongly , how to edit it ?

what is found is for a measuring point if i enter one reading , one measuring document is posted

suppose if the reading entered and saved by me is wrong and i want to edit how to do ?

if i go to IK12 and try to change the measuring document posted i could not edit

is there any way to edit the wrong readings entered for measuring points ?

regards,

madhu kiran

[former_member187991 · Accepted solution]

hi

you cannot able to edit the measurement reading ,you have to execute the Reversal indicator in edit mode and check

regards

thyagarajan

[Former Member · Accepted solution]

Hi,

You mean to say i have to go to IK12 , enter the measuring document ...go to functions ..reversal indicator ..set ?

Then will it not display in IK17 ?

If i have to make a report then the measuring documents with reversal indicator set should be excluded ?

pl confirm me

regards,

madhu kiran

[Former Member · Accepted solution]

Have you seen the Reversal indicator Radio button in IK17 Selection screen?

Babu

[Former Member]

Madhu,

No it is not possible. The transaction is basically a fast entry transaction for capturing measurement documents.However, why is the number ranges a concern? you should be able to Configure the number range as required.

Regards

Narasimhan

[Stiflers]

Number of Entry List

[Former Member]

Hi Madhukiran,

i belive that you are using Auto Measurement Document Transfer Functionlty.

So by removing this u can stop so.

Regards,

Ramesh