Mass Change of BOM

[Former Member]

Hi All

I need to swap a material in the BOM which can be done through CS20 but at the same time the new component used is not with same qty in each BOM, It varies from BOM to BOM. Hence is there any option where the mass change can be selected for BOM and individually qty can be changed?

Regards

Divya

[Ramm_Shenoy · Accepted solution]

Divya,

Yesterday there was a similar question on this forum. To which I replied as follows.I hope this helps you find resoultion.

"You can use SAP Engg workbench to do this update for you. Tcode is CEWB.

steps are

1. Select current work area as BOM item (SAP_ITEM )

2. On item tab select the component you want to replace & enter plant

3. Select LOAD BOMs & Tasklist icon.

4. System will load all the BOM's that have that item. If a Bom has multiple items with same component number , multiple lines of BOM are displayed.

5. Select the change ( pencil ) icon on the screen

6. The component columns can now be changed. Ie insert the new component number for each of the bom's.

7. Hit save icon.

8.System will display message worklist saved.

This tcode should resolve your need to mass change multiple bom items. "

thanks,

Ram

[former_member196530]

Dear

It is better to go for getting a BDC developed for all the mass changes in the BOM.

Using CS20 you can only change a single component and replace with a new material. I think BDC is the best alternative.

Refer this thread :

Hope this will be useful

Regards

JH

[former_member184655]

Dear Divya,

Perform the mass component change using T Code CS20 and then the component quantity change in T Code CEWB.

Check and revert.

Regards

S Mangalraj

[Former Member]

Dear Divya,

You can use CEWB for your requirment

Work area would be BOM item - SAP_ITEM

For steps refer below link

[;

Regards

Madhu

[former_member207022]

Dear

Try with t.code CEWB

Regards

Ganesh