on 09-07-2015 6:58 PM
Hi guys,
Hope you are good.
I was uploading my material master data on PRD client through LSMW recording but after some materials it jumped to material number 100000138.Now I have seen buffer solution and this scenario tested on Dev client its working pls give me suggestion that can i change the buffer settings to zero %.Is it alright if I change the buffer then I will not face any wrong impact in future.
Thanks in advance
Regards
Atif
And beside of all KBA or OSS notes has this been discussed countless times in SCN
Search term / number of hits:
gap number range 506
buffer number range 2487
skipped numbers range 635
Please make sure you searched before you post a question.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please read these KBA documents:
1855914 - Possible reasons for gaps in the material document number range
1646025 - Material number skipping while creating material in transaction MM01
Additionally check this OSS note 62077 - Info: Internal number assignment has gaps
These all notes have explained about all possible reasons for a number range gap. You have to analysis more with the help of these notes.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Go through the notes: 1679514 - Material, customer, vendor numbers not assigned continuously and 678501 - System stoppage, locks on table NRIV which explains the SAP recommendations.
Regards,
AKPT
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
| User | Count |
|---|---|
| 2 | |
| 2 | |
| 1 | |
| 1 | |
| 1 | |
| 1 | |
| 1 | |
| 1 | |
| 1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.